Online certificate training program for the Fundamentals of ISO 1101, Geometrical Tolerancing (G&T).

This training module will be available for 60 days after payment has been received.

Professional Development Hours (PDH) earned = 4.0 hours (Takes approximately 4 hours to complete).

This is an entry level training program and is best for those whom need an introduction to the concepts of dimensioning and tolerancing per. ISO 1101, Geometrical Tolerancing (G&T).

The program is divided up into nine separate training modules with quizes and one final test. Training modules are presented in a Power Point fomat with voice narration. Training pace is controlled by learner and all training modules may be repeated multiple times. The individual training modules will take between 10 and 25 minutes and include:

• Down-loadable Geometrical Characteristic Reference Chart

• Differences between ASME and ISO geometic characteristics and symbols.
• Glossary and Terms
• Introduction and ISO Rules
• Limit Tolerances
• Datums
• Datum Targets
• Tolerance Frame
• Form Tolerances
• Orientation Tolerances
• Location Tolerances
• Profile Tolerances
• Run-out Tolerances
• Final Knowledge Test (required for certificate of completion)

One must receive an 80% correct or greater on all training modules quiz’s, as well as the final knowledge test to receive the Certificate of Training (instant download).